NFC RFID Reader PN532

Aus Aptofun WIKI
Wechseln zu: Navigation, Suche

AptoFun NFC/RFID Reader PN532 for Arduino The Evaluation Boards Reader Module V 2.0 with 1 x RFID 13.56MHz/ 1K Transparent White Card


Description

RFID/NFC module is a Near Field Communication interface for Arduino build around the popular NXP PN532 integrated circuit and SPI communication between Arduino and NFC module.. RFID/NFC is a short-distance radio technology that enables communication between devices that are held close together. RFID/NFC traces its roots in RFID technology and is an open platform technology standardized in ECMA-340 and ISO/IEC 18092. RFID/NFC technology is regulated by Near Field Communication Forum which standardizes NFC communication between devices -- how they pair, share data and allow a secure transaction to happen.NFC Forum develops and certifies device compliance with NFC standards . NFC operate on ISM band of 13.56 MHz Frequency. NFC communication range is up to 10 cm. But, this is limited by the antenna and power radiation design. Most devices work within a range of 10mm. NFC Shield antenna is designed to work within a range of 1cm. NFC Shield provides all necessary circuitry for PN532 like 27.12Mhz crystal, power supply. It also beaks-out the I/O pins of PN532 for easy access.

NFC RFID Reader PN532 1.jpg

Features

  • The maximum communication range of this NFC Module is about

7cm

  • Three communication interfaces: SPI, IIC, UART
  • Supports ISO 14443A/MIFARE
  • Supports ISO 14443B in reader/writer mode only
  • Support for handheld devices
  • Support a variety of microcontroller
  • IO Operating voltage: 3.3V or 5v
  • Size:85mmx51mm

Application

  • Contactless payment
  • Transportation
  • easy to use
  • Smart goals
  • Social Media

Electrical Characteristics

Supply Voltage Supply Voltage - 5 V
Supply Current 1.5 100 2000 mA
High input voltage 4.8 5 5.5 V
Low input voltage -0.3 0 0.5 V

Pin information

Datei:NFC RFID Reader PN53·2 2.png

G40SNr.png

C4nS7H.png

Communication Interface Description

NFC's SPI, IIC, UART communication port switch to toggle through the jump to take. when using the SPI communication port, SEL0 jump to GND, SEL1 jump to 3.3V; When IIC communication port, SEL0 jump to 3.3V, SEL1 jump to GND; when using UART communication ports, SEL0 jump GND, SEL1 jump GND.


Revision History

REVISION DESCRIPTION RELEASE DATE
V2.0 Initial version 1/13/2013

Example